Routering


The daggerboard can be used, now. I drilled a hole in the bottom with an extra long drill through the dagger board box. With a file I made this hole wider. Then the most exciting part had to be done: the routering. With a router/ edge cutter I followed the inside of the daggerboard case. The router has a little wheel for this purpose. The result was a professionally shape aperture. Job done.


Reacties

Een reactie posten

Populaire posts van deze blog

To make or to buy

Afbeelding
My boat can be built with a kit. Cheasapeak Light Craft do sell them for about $1100. And if you want to sail with it, you have to spend an extra $955. I want to save some mosatisfactory to make everything by yourself. The boat will be a saling boat. You can buy a simple aluminum mast, boom and gaff, but I willl make them of wood and epoxy. It can't be that complicated. The best way to prevent them from warping is to glue two halves with epoxy. Because it is still freezing in the shed, I have to wait until it is warm enough. Today I have studied sailmaking. Sailrite in the USA soes sell kits for sewing it. The simpel little sail kit still costs $165. Sailmaking is not easy. It is not just a 2D square but it has to have a sort of curve in order to make the boat sail. I have found software that can help you to design the exact parts of the sail. It generates a CAD file whoch can be used in a sailcut machine. I hope to find a way in which I can print it scale 1:1. I expecte...
Meer lezen

Sanding

Afbeelding
The epoxy of the glued parts has hardened finally. Only after a day. It must have been the temperature in the attic and the temperature of the wood which came out of the cold shed just before the epoxy job. Making every edge of the wood parts smooth is costing more effort than expected, especially the holes in the aft and bow transoms and in the daggerboard. I have made a simple sanding tool on the drill, which will save time. Next thing is to glue the trusses. It is made of 2 x 2 planks, holded together by six bolts. I need to find appropriate bolts with nice butterfly nuts.
Meer lezen

Review

Having used the boat for nine months now, I can give a sort of review. First: until now I only have rowed the boat. Sailing will soon be possible, because I finally made the sail. But since the completion of the boat, I rowed it weekly. What can I say? Well, rowing with it is fun. Some points: You need something like a cushion as a seat. I used a piece of foam which I normally use for my knees when gardening. When the wind blows more than 3 Bft, waves make the boat wet. You will need a small bucket. With head wind, rowing is a lot heavier. The boat can carry a lot of load. I have transported probably a hundred kgs of timber in the boat without any problems.  With some load on the backseat, the boat seems to be 'flatter' on the water.  Position of the oars is perfect. The handles of the oars are not perfectly round. It would be better if they were. The diameter is a bit small. A couple of mm's more is better for me. After two hours of rowing, I get blisters. The me...
Meer lezen